The air filter of the Priora car (16 valves) ensures the purity of the air that is used to create the fuel-air mixture. The air on the road is not entirely clean, which is caused by dirt and dust, so the air filter on a Priora car is changed every 15-20 thousand kilometers - the price of this element is 200 rubles and more. (in city traffic it is usually changed every 30 thousand kilometers). You can change the air filter of a Priora car yourself - in short, the replacement is to unscrew 4 bolts, remove the air filter pipe and install a new part - for this it is not at all necessary to contact a technical center. In the article below you will find the article number of the factory part. Read the article to the end and you will learn everything about light machines!
Why change the air filter
The fuel-air mixture, which is created in the injector, enters the combustion chamber. In four strokes, all particles of dust and dirt that are mixed with air leave microcracks and small scratches on the walls of the chamber and on the piston. They basically “scratch” everything that comes their way. The air filter on the Priora is not installed for “beauty”: air flow passes through it. Its task is to contain the largest possible amount of dust and dirt and prevent them from getting into the engine. Those. it does not stand simply to allow air to pass through; he cleans it up to working condition.
Every time a worn consumable made a “mistake” when dirt penetrated inside the cylinder, the injector sent commands to increase the proportion of fuel in the fuel-air mixture. It became oversaturated, consumption increased. Not only is the engine life reduced due to such “impacts”, but the owner’s wallet is also thinner. Practice shows that timely replacement is cheaper than the cost of gasoline.
Original
Most car owners prefer to buy and install original spare parts. When the Lada Priora is released, a LADA air filter under article number 21120110908082 is installed at the factory. A filter from the BIG brand can also be installed out of the box. You can find it by catalog number GB-320.
The price of the original air filter for the Lada Priora injection engine (16 valves) is from 200 to 400 rubles.
Please read the packaging carefully before purchasing. Make sure that the box is made of high quality, it contains only official logos, and there are no extraneous images or inscriptions. Check the filter for damage, including torn bellows. This way you will avoid buying a fake at the price of the original.
How to replace the air filter on a Lada Priora - instructions
For Priora, this is an ordinary “consumable”. You need to know its location and be able to replace it, because this is the simplest operation for maintaining any car. To replace the air filter in question, you only need to follow a few steps:
- Open the hood. Find the black plastic box to the right of the engine; this is the housing. For your own convenience, you can remove the negative terminal from the battery and remove the wire block from the mass flow sensor (mass fuel flow sensor).
- The air filter housing cover is secured with four screws - unscrew them with a Phillips screwdriver and remove the cover.
- Slightly move the corrugated air duct and remove the used consumable. Do this carefully: it is held in place by a rubber seal, so all movements should be smooth. Even if it seems clean and you don’t want to change it, do it: all the dust and dirt will not be visible to the naked eye.
- Vacuum the housing housing from sand and dust. Insert the new part tightly in place of the old one, making sure that the rubber is adjacent to the plastic casing.
- Place the cover and tighten the four screws. Connect the wire block and the negative terminal to the battery.
Now the fuel-air mixture will contain fewer dust and dirt particles. Priora will again be dynamic, fuel consumption figures will be encouraging, and the engine will not suffer any damage from the operation of the new consumables.
Door Removal Tools
Before starting the manipulations, you need to prepare the tools. To work you will need:
- heads for 10 and 13; key - “ratchet”; head extension; Torx T20 bit; adapter for nozzle; Phillips screwdriver.
Trim Removal Tools
This is a highly specialized tool, not every car owner has it. In this case, you may have to purchase new upholstery fasteners, since the old ones may break if they are exposed to inappropriate tools. You can try replacing the blades with a shoe knife or similar tool, but a good result is not guaranteed, since you can, again, break the fasteners or scratch the upholstery.
Filter models - analogues
Air filters produced by the following manufacturers are suitable for the VAZ 2170 Priora:
- Nordfil - AN1014;
- TSN - 9140;
- Filtron – УТ000072199;
- Motor-superUT000072199;
- Bosch - 1 457 429 061;
- Knecht (Mahle Filter) - LX 220;
- Fram - CA3399;
- Kolbenschmidt - 50 013 059.
Filters from these manufacturers are sold at the same price. Their quality can be assessed by the “mesh”: if it is too dense, it will create air resistance, and the volume entering the injector will noticeably decrease - fuel consumption will increase again, Priora will not be so fast and dynamic.
The damper drive does not work
It is impossible to check whether the Priora recirculation valve is working (on cars with the Panasonic climate system) by viewing errors in the operation of the system - the corresponding codes are simply not provided. Therefore, it is necessary to perform the following actions in accordance with the algorithm described in the diagnostic card:
- Use a multimeter to measure the voltage level between ground and contact No. 1 going to the mode switch;
- if the obtained value corresponds to the on-board network voltage, there is an open circuit in the recirculation switch section;
- otherwise, you need to measure the voltage between ground and contact No. 2 of the recirculation button when it is pressed;
- if the measured value is equal to the on-board network voltage, the switch itself is faulty, and then it must be replaced;
- otherwise, use a multimeter to measure the state of the recirculation key;
- if the value is equal to the on-board network voltage, there is an open circuit in the area between the mode activation key and the SAUKU heater controller;
- if not, we proceed to measuring the voltage in the area between ground and contact No. 1 of the damper solenoid valve (the button for turning on the recirculation mode must be pressed);
- if the obtained value corresponds to the voltage of the on-board network, there is a break in the electrical circuit in this area;
- otherwise, there will be an open circuit in the ground circuit of the damper drive valve.
The pinout of the Priora recirculation button is described in detail in the circuit diagram of the Panasonic climate control system. If the recirculation malfunction is caused not by an open circuit or a breakdown of the solenoid valve itself, but by a malfunction of the damper, replacing it can be quite difficult for an unprepared car owner.
If you go to a car service center, it will cost a pretty penny (about 10 thousand rubles), since the technicians will tell you that you need to remove the entire stove, drain the antifreeze, and also remove freon from the air conditioning system. You can do this yourself, and without draining the antifreeze and pumping out the refrigerant. Therefore, it makes sense to describe the procedure for replacing the vacuum drive if the Priora interior air recirculation damper does not work:
first you will need an L-shaped screwdriver - it is not sold in stores, but it is not difficult to make by bending any existing one made of fairly soft metal
We use it to unscrew the lower screw, which is located very inconveniently - there is a hole there large enough to stick your hand through and perform the necessary manipulations;
the top screw is hidden behind the plastic of the stove body - it needs to be drilled exactly opposite the screw; disconnect the damper rod, for which you need to pull it to the left with a little effort; now the drive is free, all that remains is to pull it out (pull it a little to the left and press in the direction of the engine compartment - it should fall down), you need to pull it out carefully, since it can cling to surrounding parts;
the procedure for inserting a new vacuum drive is also quite tedious - first we try to insert the valve into its normal place; the second step is to get the drive tube into the hole located in the lower part of the heater; put the hose on the valve itself; we tighten the screws in the reverse order (you will have to tinker with the bottom one, so you don’t have to tighten it - the valve will be held quite securely even without the bottom screw).. As you can see, you can replace the flap drive of the Priora recirculation system yourself
As you can see, you can replace the flap drive of the Priora recirculation system yourself.
Replacement process
The air filter on a Priora can be replaced by any person who has held a screwdriver in their hands at least once in their life.
Required tool:
To carry out the work, you will need to open the air filter housing.
- Using a screwdriver, unscrew the 4 bolts of the filter box cover and lift the cover up.
We take out the old filter, clean out any remaining dust and dirt from the box with a vacuum cleaner or brush.
We install the new filter in the same position as the old one, with the slots along the direction of the car.
Source
Precleaners
Devices of this kind are installed to strengthen a cylindrical filter. It is a white strip consisting of synthetic fibers. On Lada Priora, this part is necessary if the car constantly drives over rough terrain.
The pre-cleaner absorbs about 40% of the dust entering the engine. It absorbs oil vapors, ash and unburned carbohydrates in the air. The part must not be washed, otherwise it will be damaged.
It is not recommended to wash air filters and the cardboard from which the curtain is made. It is better to avoid getting liquid on them. Wetting the Lada filter with oils and other substances is strictly prohibited, as this leads to an increase in the resistance of the device and becomes the reason why it stops passing air.
Many filters are oiled to reduce resistance using an industrial method. Also, the filter device should not be blown out, because small particles of dirt get into the pores of the element and often lead to rapid wear of the motor.
Experts advise replacing filters after 15 thousand km. The use of the car is also taken into account. If it “runs” every day on roads that are full of dust, replacement should be carried out more often.
You can check the condition of the air filter yourself. To do this, the hood of the Lada Priora car is opened and the metal clips are snapped off. If there are leaves, dirt, or fluff there, the filter device needs to be replaced. For Lada, it is necessary to replace not only oil filters, but also air filters. Timely assistance to the car will simplify the life of the driver and save him money.
We dismantle the front bumper of the Priora with our own hands
How to properly change the cabin filter on a Priora?
Error codes for Lada Priora
How to adjust the clutch on a Lada Priora?
